Defining parameter settings

  1. Connect the HID Joystick unit to a PC. Use a standard micro-USB - USB A cable.
  2. Open the Configurator in the Administrator mode. This will shorten the time it takes to load all the parameters (30 sec - 2 min).
  3. Press and hold the mode button on the interface for 5 seconds to enter the configuration mode of the HID Joystick. Wait until all parameters are loaded.
    Note: The HID Joystick itself cannot be used to program the device.
  4. Configure the parameters with the software or upload a pre-configured set of parameters into the device.
  5. Save the configuration to the device.
  6. Test the configuration and adjust if necessary.