Micro Joystick HID installation

  1. Define the position of the joystick.
    There is an arrow on the bottom of the Micro Joystick to indicate the default 'north' direction. This can be adjusted, however, with the Configurator Software.
  2. Place the mounting ring around the joystick housing.
  3. Secure the Q2M half clamp to the mounting ring.
    Use an Allen wrench to mount the 20 mm bolt.
    Note: It is not advised, but you may mount the joystick without using the Q2M half clamp.
    CAUTION: Tighten the screws firmly, but not excessively. Excessive force may damage the unit.
  4. Slide the unit over a Q2M rod or the ¼”Q2M Rod 50 mm Threaded UNC 1/4x20, or any other 6 mm rod, to position the Micro HID Joystick:
  5. Place and secure the interface unit and all cabling on the desired location.
  6. If required, place up to four switches (via splitter cables), secure their cabling and insert their connections.